Ques.11. In microwave telemetry, repeater stations are required at every
- 2 km
- 5 km
- 40 km
- 100 km
Ques.12. Which of the following devices are required to measure three-phase power?
- One watt meter
- One watt meter and one voltage transformer of 1: 1 ratio
- One watt meter and two voltmeters
- None of the above
Ques.13. If the excitation of a 3-phase alternator operating on infinite bus bars is changed, which one of the following will also change?
- Active power of machine
- Reactive power of machine
- The terminal voltage of the machine
- Frequency of machine
Ques.14. What is the approximate input impedance of a CRO?
- Zero
- 1 MΩ
- 10 Ω
- 10 µΩ
Ques.15. Which of the following set of IE rules related to additional provisions for use of energy at high and extra high voltage?
- IE Rule 61-A
- IE Rule 50
- IE Rule 64 A
- IE Rule 50 A
Ques.16. In which of the following type of digital voltmeter, the input voltage is measured in the form of frequency?
- Ramp type
- Potentiometric type
- Integrating type
- None of the above
Ques.17. By increasing the transmission voltage to double of its original value the same power can be despatched keeping the line losses
- Equal to its original value
- Half the original value
- Double the original value
- One-fourth of the original value
Ques.18. In capacitance grading, three dielectric materials with permittivities ε1, ε2, & ε3 are placed as shown below.
Which of the following condition is true, when all the dielectric materials are subjected to the same maximum stress?
- ε1= ε2 = ε3
- ε1> ε2 > ε3
- ε1< ε2 < ε3
- ε1 ε2 ε3 = 1
Ques.19. The role of micro-stepping mode in stepper motor is to
- Have rotation to 100% of angular displacement for single stepReattempted
- Have 50% of angular displacement for a single step
- Have twice the steps under half-stepping mode
- Have lower angular displacement similar to a single step in a motor
Ques.20. The sensitivity of 200 µA meter movement when it is used as a D.C voltmeter is given by
- 500 Ω/mV
- 5 Ω/V
- 0.5 Ω/V
- 5Ω/mV