# Op-Amp Slew Rate MCQ [Free PDF] – Objective Question Answer for Op-Amp Slew Rate Quiz

1. Slew rate is defined as the rate of change of

A. Output voltage with respect to time
B. Input voltage with respect to time
C. Both output-input voltage with respect to time
D. None of the mentioned

Slew rate is the maximum rate of change of output voltage caused by a step input voltage with respect to time.

2. How the slew rate is represented?

A. 1V/ms
B. 1V/s
C. 1V/µs
D. 1mv/S

Slew rates are usually specified in V/µs. For example, 1 V/µs means that the output rises or falls no faster than 1V every microsecond.

3. The natural semiconductor LH0063C has a slew rate of

A. 1400V/µs
B. 6000V/µs
C. 500V/µs
D. None of the mentioned

National semiconductor LH0063C has a slew rate of 6000V/µs. Generally, a practical op-amp is available with a slew rate from 0.1V/µs to well above 1000V/µs.

4. Rise time is specified for

A. Large signal
B. Medium signal
C. Small signal
D. All of the mentioned

Rise time is specified for small signals, usually when the peak output voltage is less than one volt.

5. Op-amps with wide bandwidth will have

A. Increase in output
B. Higher slew rate
C. Low response time
D. None of the mentioned

An op-amp slew rate is related to its frequency response. Usually, op-amps with wider bandwidth have a higher (better) slew rate.

6. Which factor is responsible for causing the slew rate?

A. Internal capacitor
B. External resistor
C. None of the mentioned
D. Both internal and external capacitor

Capacitors require a finite amount of time to charge and discharge. Thus, a capacitor inside or outside the op-amp causes a slew rate.

7. Find the value of the capacitor, if the rate of change of voltage across the capacitor is 0.78V/µs and current= 12µA.

A. 5µF
B. 2µF
C. 10µF
D. 15µF

Rate at which the voltage across the capacitor increases is given as dVc/dt= I/C

=> C= I/ (dVc/ dt)

= 12µA/0.78V/µs

= 15.38 ≅15µF.

8. Find the slew rate of op-amp from the output waveform given below? A. 3.4V/µs
B. 10V/µs
C. 20.66V/µs
D. 16V/µs

Slew rate is defined as the maximum rate of change of the output

SR = 3.1-(-3.1v)/ (0.6/2)µs

=6.3/0.3 = 20.66Vµs.

9. For the circuit shown below, calculate the rate of change of the output signal A. Vm ωcosωt
B. Vm cosωt
C. Vm cosωt/ωt
D. Vm cosωt/ω

The given circuit is a voltage follower circuit. So, input voltage = output voltage

=> Vo= Vmsinωt

=>∴ the rate of change of the output voltage

= dVo /dt= d(Vmsinωt)/ dt = Vm ωcosωt.

10. At what condition, the output of op-amp will be free of distortion?

A. Slew rate > 2πfVm /106 V/µs
B. Slew rate > 2πfVm /106 V/µs
C. Slew rate ≥ 2πfVm /106 V/µs
D. Slew rate = 2πfVm /106 V/µs