A. directly proportional
B. indirectly proportional
C. exponentially dependent
D. does not depend on
Answer: A
The gain of the MESFET is directly dependent on the transconductance and output conductance of the device.
2. Transconductance gives the relationship of
A. Ids and Vds
B. Vds and Vgs
C. Ids and Vgs
D. Ids and d
Answer: C
Transconductance describes the relationship between the output current Ids and the input control voltage Vgs.
3. Output conductance gives the slope of linear characteristics.
A. true
B. false
Answer: B
Output conductance is also used to measure the gain of MESFET and it gives the slope of output characteristics.
4. The transconductance value in cut off region is
A. Vds
B. 1
C. cannot be determined
D. 0
Answer: D
The transconductance value for the cut-off region is 0 and it is the relationship between Ids and Vgs.
5. GaAs device has
A. high bandwidth
B. high transconductance
C. low gate capacitance
D. all of the mentioned
Answer: D
GaAs devices have high transconductance, very low gate capacitance, high gain, and high bandwidth.
6. Transconductance is not influenced by transistor size.
A. true
B. false
Answer: B
Transconductance is independent of process and slightly influenced by the transistor size. In GaAs transconductance are both process and size-dependent.
7. Switching speed does not depend on
A. gate length
B. gate voltage
C. carrier mobility
D. doping level
Answer: D
The switching speed of the device depends on gate length, gate voltage, and carrier mobility in the channel but does not depend on the doping level.
8. The output conductance value in cut off region is
A. Vds
B. 1
C. cannot be determined
D. 0
Answer: D
The output conductance value for the cut-off region is 0. This gives the slope of output characteristics.
9. To improve the switching speed
A. voltage swing should be increased
B. voltage swing should be decreased
C. gate length should be increased
D. gate thickness should be increased
Answer: A
To improve the switching speed, the logic voltage swing should be increased and the gate length should be reduced. The increase in switching speed results in an increase in dissipation.
10. The device turns off when
A. Vlow > Vt
B. Vlow < Vt
C. Vhigh < Vt
D. Vhigh > Vt
Answer: B
To establish the logic voltage swing and to turn off the device, Vlow the low logic voltage level must be less than the threshold voltage Vt.
